Inside the car, connect the end of the amp wire into the distribution block at the rear of the glove box. You can now connect the other end of the amp wire to the battery as the fuse is not in the holder, or this can be left til the end. If you look from the passenger footwell, up behind the glovebox, you will see the wire you have just fed through. Then i pushed the amp wire through the gromit. I pushed a flat headed screwdriver through the gromit creating a small slit. This is where the amp wire will need to go through. The plastic will then slide down off the windscreen. To do this, remove the black rubber which holds the plastic in place and undo the screws. Then open the bonnet and remove the black plastic at the rear of the bonnet and the bottom of the windscreen. Cut approx half a metre off the amp wire then connect the inline fuse to each end of the wire, but take the fuse out of the holder. Next stage is to connect the positive amp wire to the battery after feeding it through the bulkhead. On the rear side of the amp, place one "spikey" velcro tab in each corner as shown in the pictures. 5 x electrical wire connectors (clip type as shown in picture).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |